| The new Ranger PM7000 power analyzer
and logger sets new standards with over 500 logging channels,
and it is waterproof and rated at Category IV for maximum
operator safety.
The PM7000 is used in a wide range of power measurement
and analysis applications on industrial sites and by power
distribution companies and regulatory authorities. Incidents
such as motor start surges, transients, sag, flicker, notch,
ring, negative sequence voltage, unbalance, etc are easily
seen and can be measured in detail for several weeks.
It is light and portable as well as being self powered
by A Phase, and can log eight inputs (four volts, four
amps) at up to 20,480 samples per cycle in 60 Hz installations.
As well measuring and logging volts and current, the
PM7000 analyzes a wide range of parameters including
harmonics and the increasing problem of Flicker. Compliant
to IEEE 1453.
Just as important as the industry leading PM7000 hardware,
is the quick and easy to use PRONTO software. Every Ranger
is supplied with PRONTO the well known display and reporting
software which enables a quick and detailed appraisal
of all the data collected.
The PM7000 is supplied with a Bluetooth enabled Pocket PC PDA for remote display
and configuration before, during and after logging. There is also USB and USB
Jump Drive connectivity. The PDA shows status, waveforms, trends, disturbance
incidents 3D Bar, CBEMA, Severity Duration vs. Time, Harmonics, phasors and many
more. |
|
